 |
|
Message Board
|
|
 |  | |
 |  | |
 |  | |
 | ||
|
|||||||
| NJFishing.com Boating Use this board to discuss anything related to boats and boating in NJ |
 |
|
|
Thread Tools | Display Modes |
|
#1
12-24-2018, 10:50 AM
|
||||
|
||||
Prop service
I have twin F150s with stainless props. The props look good but I as thinking of having them serviced. Is this a waste of money? I don't feel or think there is any vibrations ect.. is there a rule of thumb? Thanks for the input!
__________________
The two best days to fish are yesterday and tomorrow. "You shoulda been here yesterday" and "Tomorrow looks good!" 
|
|
#2
12-25-2018, 07:33 AM
|
||||
|
||||
|
Re: Prop service
If you have no vibrations I wouldn't worry about it Tony...
__________________
Gerry Zagorski <>< Founder/Owner of NJFishing.com since 1997 Proud Supporter of Heroes on the Water NJFishing@aol.com Obsession 28 Carolina Classic Sandy Hook Area 
|
|
#3
12-31-2018, 10:56 AM
|
||||
|
||||
|
Re: Prop service
Gerry is right. Nice smooth edges you are fine. The other reason if there was slippage. Since sheer pins are a gone with leaded gas, the use a rub hub to allow limited slippage.
if things have been hit and stalled the motor you are taxing it. Normally there would be prop blade damage but NOT always. A fouled line in your wheel or running aground in sand will not damage a blade, but will exercise the rub hub. So if there is no visible damage or forced stalls you should be perfectly fine. Quote:
__________________
Capt. Debs Tow boat captain/salvor 50 ton USCG Master NJ Boating College- Lead Instructor Big time hottie crabber 
|
|
|
|
Linear Mode
