 |
|
Message Board
|
|
 |  | |
 |  | |
 |  | |
 | ||
|
|||||||
| NJFishing.com Boating Use this board to discuss anything related to boats and boating in NJ |
 |
|
|
Thread Tools | Display Modes |
|
#1
03-17-2018, 11:12 AM
|
||||
|
||||
Re-core swimplatform
Took off the old platform because of rot. I ground it all out to re-core it but there are many materials to choose from, it was end grain balsa. The foam products , from what I've read, do not hold mounting screws well. So with that in mind do you go back to wood? any thoughts?
__________________
The two best days to fish are yesterday and tomorrow. "You shoulda been here yesterday" and "Tomorrow looks good!" 
|
|
#2
03-17-2018, 12:13 PM
|
||||
|
||||
|
Re: Re-core swimplatform
If you are replacing balsa the high density foams will certainly hold a screw better than balsa...Charlie
__________________
 Greetings from Lake Hopatcong...
|
|
#3
03-18-2018, 03:14 PM
|
||||
|
||||
|
Re: Re-core swimplatform
I used SeaCast in my last ride for an engine mount that was fubar. Worked great. Def something you can drill/tap and has the strength for a swim platform. Something to look into.
__________________
OX66 ADDICT KUKUBABY FISHING TEAM EST. 1995
|
|
#4
03-19-2018, 05:23 PM
|
||||
|
||||
Re: Re-core swimplatform
Thanks Duff, gonna give SeaCast a shot.
__________________
The two best days to fish are yesterday and tomorrow. "You shoulda been here yesterday" and "Tomorrow looks good!"
|
|
|
|
Linear Mode
