 |
|
Message Board
|
|
 |  | |
 |  | |
 |  | |
 |  |
|
|||||||
| NJFishing.com Boating Use this board to discuss anything related to boats and boating in NJ |
 |
|
|
Thread Tools | Display Modes |
|
#1
03-12-2023, 12:08 PM
|
|||
|
|||
thread pitch
I have a 2009 f250 BTXR yamaha 4 stroke.While removing the lower unit I stripped the female threads on the longer bolt next to the anode bolt.Does anyone know the thread pitch of this bolt is.I need it to buy a tap to re-thread it.Thanks
|
|
#2
03-12-2023, 05:54 PM
|
||||
|
||||
|
Re: thread pitch
Not sure .. but suggestion.
The manufacturers usually use same pitch on similar sized bolts in that area. Remove another nut nearby. and see if it fits that stud. Eureka. You have pitch. Or buy feeler guage set to match the pitch of threads per inch on the nutless stud youre looking to find a nut for. Just a suggestion. Quote:
__________________
Capt. Debs Tow boat captain/salvor 50 ton USCG Master NJ Boating College- Lead Instructor Big time hottie crabber 
|
|
#3
03-16-2023, 08:38 AM
|
|||
|
|||
|
Re: thread pitch
Thanks for the reply Captain. I took one of the bolts to Ace hardware. I didn't realize how easy it was to match up to get thread pitch. Lower unit is back on.
|
|
#4
03-16-2023, 10:48 PM
|
||||
|
||||
|
Re: thread pitch
A happy ending.
 Quote:
__________________
Capt. Debs Tow boat captain/salvor 50 ton USCG Master NJ Boating College- Lead Instructor Big time hottie crabber
|
|
#5
03-16-2023, 10:48 PM
|
||||
|
||||
|
Re: thread pitch
Odd question.... was it stainless steel bolt?
Quote:
__________________
Capt. Debs Tow boat captain/salvor 50 ton USCG Master NJ Boating College- Lead Instructor Big time hottie crabber
|
|
|
|
Linear Mode
