Cutting a rod tip?

[RussH]

I have a 7' Ugly stick spinning combo that has to be 25 years old. I used it for tons of in shore stuff when I was a novice and used to loan it to friends. The tip got super screwed up on my last move. Other than that the reel and rod are perfect. Can I cut the tip right above the next eye with a dremel wheel and still have a functioning rod? I know it will be stiffer. But other than that?

[frugalfisherman]

Better than throwing it away.

[Gerry Zagorski]

Yep cut the tip down and glue a new rod tip on.

[CadiShackFishing]

Yes, cut the tip and glue on a new one and the pole is as good as new. If you don't want to do it your self most sporting goods stores can do it.

[RussH]

Oh, so I can't just cut it to the next eye? That's cool I'm sure I can epoxy a new tip on. I'll look into what I need to buy. A fun project at least. Not worth having someone else repair. Minorly sentimental because I THINK it was my first rod I bought for myself when I was a teenager.

[RC.]

When you say the tip got screwed up, do you mean the tip top (the top guide) broke? if that's the case, you can heat it with a lighter and remove it. If the rod actually broke, you can cut it and put a new tip on- do not use epoxy. They make glue sticks to put a new tip on. Epoxy is permanent and when the guide breaks (and this is common), you want to be able to get it off.

If and when you cut it, use the corner edge of a file and just go around it until you get through. Since the tip diameter is so small, you want to be delicate.