Outboard - Spark Plug Help

This year I rotaited the fouled but cleaned plugs from last year, fogged them and brought my 1 year old plugs home. The help I need is what should I use to clean the plugs with so that I can re-use them next year?

[mboy]

For the under $50 they cost, why not buy new ones?

I change mine every year.

6 Plugs at like $3-4 each.

Originally Posted by mboy

For the under $50 they cost, why not buy new ones?

I change mine every year.

6 Plugs at like $3-4 each.

I have always done that as well. But if you think about it, how often do you change a car spark plug? You use it for thousands of miles, why shouldnt a boat spark last as long? Maybe its not a good idea, thats why I posted it....guys with more intel than I on the subject. You are right, its not the most costly thing on the boat.

[mboy]

They just might, but for under $50, why chance it?

They live around SW, so rust is somewhat a factor ( I have seen them on outboard plugs before for sure) and they are not constantly run like a car engine.

To me, just not worth taking a chance on an expensive engine on such cheap parts.

Most certainly could be all in my mind.

[MoparCharlie]

Well if it's a 2 stroke engine any comparison to a car is like comparing apples and oranges.Burnt oil leaves debris that is not found in automobile engines,unless they are pushing blue smoke out the exhaust.
If it's a 4 stroke engine a comparrison could be made.Undoubtedly a boat motor gets pushed way harder than its automotive counterpart.For the most part automobile engines live in the 2000-2500 rpm range while the boat engine usually lives in the 3500-4200 rpm range.Boats are much tougher on parts.That said I go along with the others in saying that if you are going to remove the spark plugs for the minimal cost of new ones it's cheap piece of mind to just replace them.If you are hell bent on cleaning them,an auto parts store will sell you a spark plug cleaner tool.It's basically a very small sandblaster that hooks up to a compressed air line.Be sure to clean all the debris out with carb and choke cleaner.

[Sharkyispy]

Change them out and put new ones in. I run my plugs at the start of the season for two trips to get the fog out, change out with a new set and then put another new set in mid way through the year to keep it running great. I have an older 2 cycle outboard that's been fairly good to me and want to keep it running great as long as I can.