 |
|
Message Board
|
|
 |  | |
 |  | |
 |  | |
 |  |
|
|||||||
| NJFishing.com Bait and Tackle Talk Use this board to talk about Bait and Tackle and see offers from our Bait and Tackle Sponsors |
 |
|
|
Thread Tools | Display Modes |
|
#1
09-13-2014, 07:06 PM
|
|||
|
|||
rod holder for party boat tuna
Does anyone have a good design or photo of a rod holder for party boat tuna? I have a stainless L shape rod holder and needed some advice on how to fix it to the rail and bottom. Thank you!
|
|
#2
09-15-2014, 04:27 PM
|
||||
|
||||
|
Re: rod holder for party boat tuna
Not sure what you mean...don't all PB's have built-in holders? Most add-on holders slip into the existing holder & look like an angled "T"...Of course, a safety line should be a must!!! Mostly, these "T"s are for dead sticking swordys..mostly frowned on for tuna as they're near impossible to get around when "walking" your fish...guys going for swords are out of the way as much as possible..... You can drill through your holder at a point to be determined by you & put a through bolt in to keep the holder supported in the boat's holder if it doesn't have a pin in it's bottom....Hope this helps....Catch em up...
__________________
First Mate "IRISH ROVER" fishing team(retired) First Mate "ROSE LEE" fishing team(retired) Dennis B. missed & always remembered John M. missed and always remembered I'd rather die while I'm living than live while I'm dead (Jimmy Buffett) Last edited by Pennsy Guy; 09-15-2014 at 04:33 PM..
|
|
#3
09-15-2014, 04:54 PM
|
|||
|
|||
|
Re: rod holder for party boat tuna
your hands and arms.
|
|
#4
09-20-2014, 12:53 PM
|
|||
|
|||
|
Re: rod holder for party boat tuna
I have a great set up. Works on every boat. Took years to get it right. You have to check it out. I all so have extra parts to put yours together. Check your PMs
|
|
|
|
Linear Mode
