NJ Fishing Advertise Here at New Jersey's Number 1 Fishing Website!


Message Board

NJFishing.com Your Best Online Source for Fishing Information in New Jersey - View Single Post - Fiberglass guy for pocket transducer?
Thread: Fiberglass guy for pocket transducer?
View Single Post
  #1  
Old 07-20-2017, 03:29 PM
Slip It In's Avatar
Slip It In Slip It In is offline
NJFishing.com Regular
  
Join Date: Nov 2012
Posts: 76
Default Fiberglass guy for pocket transducer?
Looking to install another transducer in my boat. Looking to have an Airmar CM599 Pocket transducer installed but need someone to glass in a pocket for it to sit in. Anyone know of any glass guy who has done this? Since its about 14 x 6 inches would hate for that pocket to break up inside the boat, would sink in a matter of minutes. Its going to be installed in a center console with good access to the bilge for transducer location.

I do not want to have a fairing block setup so please do not suggest that option.

thanks in advance
Pete
Reply With Quote