Water jet/plasma cutter
Any sponsors/members know of where I can go to get a template cut out of stainless plate, I'm putting some reinforcement in the bow for an anchor roller and mooring/pulling bitt and have some 3/16 stainless plate need cut out, really would like to hear of a water drill but I'll take a good plasma and also gonna of course need some holes punched for roller and subframe to top frame - the latter being a 3/8" thick x 3/8" circular wide unless you have a 3/8" carriage stamp... Just throwing this one out there but maybe. We do have some marine fabricators out there , I can't wait to see the response, hopefully I can do some shopping.... And possibly not massacre my "stainless fillet table" piece of steel for something available-at a reasonable cost-
I have dimensions or could bring on trailer there , but I will have to put lights on trailer 1st so option A is better
And of course.... Thanks Guys!
|
