Trailer bearings....
 

Did a repack for a buddy who nearly had a wheel come off after first trip of the season.

Figured I'd just throw it up here. It doesn't take much to make them fail. Water sitting in the hub over winter did its toll.

Curious as to what grease everyone here is using???

Re: Trailer bearings....
 

.

Re: Trailer bearings....
 

I try to get Timken Bearings. Made in USA. Those Chinese ones burn up quick.

Re: Trailer bearings....
 

Just did mine last week. Don't know the brand but used synthetic grease. This was the first time changed. The trailer is 4 years old.

Re: Trailer bearings....
 

Will be pulling my own hubs this week. Agreed Timken is the only way to go. Difference from China made bearings is def noticeable.

Still looking at grease. Going syn route just unsure of brand.

Re: Trailer bearings....
 

#4 red and tacky, Farmer told me about it and it works great!

Re: Trailer bearings....
 

I do not think the type of grease matters much; if brackish water is inside. I now simply consider my bearings disposable, thus keep two spares and all necessary tools with tow rig.

I tend to open mine up when trailer returns to home base, let water drain out if any is in there. Leave the cap off to allow drying out until a few warm sunny days have passed. Then stuff more grease in on top of old, and re-install bearing caps. My towing is 20 miles to nearest ramp, expressway speeds.

Re: Trailer bearings....
 

And don't forget an appropriate jack to the trailer. Most totally forget about that part until too late.

Re: Trailer bearings....
 

I have to disagree. I've seen guys use any grease they had lying around as opposed to synthetic or water resistant grease. The standard auto grade stuff turns to a white milky mess when it contacts water. Syn stuff seems to hold up better when exposed to the same conditions.

Going with the #4 R&T. Maybe pull a hub off mid season and see how its holding up....stay tuned...:D

Re: Trailer bearings....
 

Salt water will destroy ANY bearings even Timkens.. I got so sick of replacing bearings, races, hubs, springs and axles on my boat trailers many years ago that I decided to do something about it.

I have 3 boats on 3 different trailers, from 14 to 18 feet and the bearings are all decades old, with no issues ever.. I know its not possible on all trailer boats, but many boat trailer combos can be set up to launch and retrieve without sinking the hubs or axles.. I never wet a hub these days and since I set my trailers up that way years ago, have never replaced a bearing, and can go a several years without even checking them.

Its not that hard to do really, if the boat isn't that big, or can be let down into the water with a power winch... for a lot of small boaters, its well worth checking it out.... bob