Re: Fluke Cuts - Action Needed by 11/30/2016
 

Done. Thanks for posting.

Re: Fluke Cuts - Action Needed by 11/30/2016
 

Done and last week renewed my RFA membership for another 3 years. Fluke fishing was my favorite type of fishing but I haven't fished salt water for about the last 6 years because of the stupid regulations. I refuse to spend all that money and go through all the trouble just to play catch and release on a bunch of shorts,sea Robbins,skates and dogfish. At least in freshwater I can keep a few hybrids. But I still support the RFA and hope someday it will be worth going for fluke again...Charlie

Re: Fluke Cuts - Action Needed by 11/30/2016
 

Thanks for supporting the RFA Charlie!!

Re: Fluke Cuts - Action Needed by 11/30/2016
 

Your welcome Gerry. A little more on the subject. Doing free things like signing petitions and the like is good and we should all do it. But our rights are being attacked by well funded organisations and the only way to keep our rights is to fight back with with well funded friends like the RFA and there are other worthy groups too. I don't rely like it but the only way to get things done is to put your money where your mouth is so to speak. I don't know what percentage of members of this site support these worthy groups but would guess or hope it is pretty high. It would be nice if all were on board and also all affected business such as boat builders,marinas,bait and tackle makers and shops,party and charter boats,etc. Like I say I would guess or hope many are but I am sure we could do better. We just have too much to loose and a lot to gain back...Charlie

Re: Fluke Cuts - Action Needed by 11/30/2016
 

dONE

Re: Fluke Cuts - Action Needed by 11/30/2016
 

done,but i just ordered 6 more dexters just in case

Re: Fluke Cuts - Action Needed by 11/30/2016
 

I shared the crap outta this on facebook.

If any of you have facebook accounts, copy Gerry's link, and paste it into your facebook status and share it with all your friends.

We need as many signatures as possible to get this ball rolling!

Re: Fluke Cuts - Action Needed by 11/30/2016
 

Done, appreciate you sharing.